Advertisement
Continue to Site »

site_header_zone


 
Trending
Tandus Centiva and Suzanne Tick Support Publicolor
Suzanne Tick. Flooring specialists Tandus Centiva and textile designer Suzanne ...
Thomas O’Brien Partners With Century Furniture
Photography by Jason Penney. If you think “vintage forms translated ...
1950's Throwbacks: 5 Outdoor Furnishings Look to the Past
  Nobody created outdoor living spaces quite like the architects ...
10 Questions With... Phil Jaffa
  For more than two decades, the U.K.’s Phil Jaffa, ...
BIG in Washington: Giant Maze Fills National Building Museum
Photo courtesy of the National Building Museum. Inspired by ancient ...

JOB ZONE

jobseekers:

employers:

 
Weekly Poll
Where has your firm seen the most growth in the first half of 2014?

    industry_article_detail_left_zone

    How Software Fundamentally Changed Design: 5+design

    Five years ago, says Stan Hathaway, managing principle at 5+design, Revit was impossible to use. It wasn’t developed enough. Hathaway's firm has been a guinea pig for programmers of Revit (and AutoCAD), meeting annually to review and create new programs to better serve the overall industry. Now, says Hathaway, “Revit is the wave of the future.”


    That said, the fabrication software is time consuming initially, it requires as much as twice the amount of time to complete the first design. But, says Hathaway, it’s profitable at the back-end because the early hours are made up with the ease of changes later on. “People change their minds a lot. There are always changes from concept to schematic,” Hathaway notes. In the past, changes to measurements like floor height meant a re-drawing of every section. Not so with Revit.


    “That’s really critical with something like a ship; every inch really counts, and engineers like it too,” says Hathaway. “You will get left behind if you don’t get more efficient.”


    Plus, clients prefer 3-D models to reading plans (5+ uses a D printer for model building that is synced with Revit renderings). According to Hathaway, thanks to smartphones and other visual stimulation, clients don’t want to use their imaginations to see a project.


    Most projects for the Hollywood, CA-based firm are large, mixed-use buildings that require coordination with many different architects. Needing to share is one hitch with employing new technology—not everyone has it. And it’s not cheap. “You have to invest,” says Hathaway. “Changing software can be an astronomical cost.” Think size of firm times $5,000 per user.


    The firm has also recently purchased Boxx computers, considered the world’s fastest for all design projects. First used in the entertainment industry by the likes of Pixar, they’re now more common in the architecture sector.



    <<Back to main article
    TVS Design
    Eric Safyan
    Gensler
    Perkins + Will

    industry_article_detail_central_zone